Flexible welding platform

Introduction to the structural composition of a flexible welding platform:

1.Worktable

The five working faces of the workbench have 100x100 mm(D28 series)or 50x50mm(D16 series)holes with grid markings.The tolerance accuracy of its five faces in terms of plane,parallel,and vertical,as well as the positional accuracy of holes,are very high.The positioning on the table and the combination between the table and other modules have sufficient precision requirements.The size of the basic countertop can be freely selected from 1000x1000mm to 4000x2000mm,and the size can be customized.

2.Module

The standard modules include positioning and clamping right angle blocks,L-shaped positioning blocks,U-shaped positioning blocks,universal stop blocks,universal clamping and positioning angle molds(adjustable from 0 to 225 degrees),V-shaped blocks and V-shaped angle molds.All modules have standard holes every 50 or 25mm interval（Φ28 orΦ16)It can achieve workpiece positioning and clamping.

3.Locking pin

This is the basic component for implementing a hole system clamping system,used for positioning and clamping.There are five steel balls at the front end of the pin bolt.After inserting them into the positioning hole,manually rotate the pin bolt clockwise(or pull the handle),and the five steel balls will pop out and lock onto the inclined surface of the hole to complete positioning and clamping;When releasing,rotate the pin bolt in the opposite direction to pull it out.The locking force of each pin can reach 5 tons and the shear force is 25 tons.There are multiple specifications for the shape and length of the pin to choose from.

4.Clamp

Clamping devices have flat,vertical,and 45 degree clamping directions;According to the operating methods,there are bolt clamping,clamping,and handle spiral clamping;There are also manual,pneumatic,or hydraulic options.The spiral clamp with compensation is commonly used.This type of clamp adds elastic expansion and contraction in the cantilever,offsetting the lateral force during clamping to compensate for the deformation of the fixture itself and the gap during insertion.The clamping force is perpendicular to the force surface.

The clamping head is made of carbon steel,stainless steel,and nylon materials to meet different workpiece requirements.If equipped with two-point or three-point clamping bridges,it is possible to simultaneously clamp workpieces at two positions of different heights.Additionally,the clamping head can be machined according to the clamped surface.