Magnesium aluminum right angle ruler

Magnesium aluminum right angle ruler material:Magnesium aluminum right angle rulers are made of aluminum alloy material(aircraft frame aluminum).Magnesium aluminum alloy is a new material for manufacturing measuring tools,recommended by the metrology department,and used for producing lightweight flat rulers,which has great advantages.

The main use of magnesium aluminum right angle ruler:Magnesium aluminum right angle ruler is mainly used for inspecting and marking the right angle of workpieces.When installing and repairing equipment,it is used to inspect the verticality of the surface of parts or components.Also used for measuring tools,instruments,and machine tools.Co construction adjustment and identification of workpieces,such as verifying the perpendicularity of instrument guide rail movement,detecting the perpendicularity error of workpiece positions,etc.

Physical properties of magnesium aluminum square rulers:tensile strength of magnesium aluminum square rulers:47kg/mm2,elongation of magnesium aluminum square rulers:17%,bending point of magnesium aluminum square rulers:110kg/mm2,Vickers strength of magnesium aluminum square rulers:HV80

The usage method of magnesium aluminum right angle ruler:Before using the right angle ruler,each working surface and edge should be checked for damage.The left and right sides of the long side of the square,as well as the upper and lower sides of the short side,are all the workpiece surfaces(i.e.inner and outer right angles).Wipe the straightedge working surface and the inspected working surface clean.

The usage process of magnesium aluminum right angle ruler:

(1)The 00 level and 0 level right angle rulers are generally used for inspecting measuring tools;Level 1 is used for inspecting workpieces;Level 2 is used for inspecting general workpieces.

(2)Before use,each working face and edge should be checked for any scratches.The left and right sides of the long side of the square and the top and bottom of the short side are all the workpiece surfaces(i.e.inner and outer right angles).Wipe the straightedge working surface and the inspected working surface clean.

(3)When using,place the right angle ruler against the working surface of the measured workpiece and use the light gap method to identify whether the angle of the workpiece is correct.

(4)To determine the measurement result,the square ruler can be flipped 180 degrees and measured again.The arithmetic mean of the two readings is taken as the measurement result,which can be the deviation of the square ruler itself.