T-shaped groove bending plate

T-shaped groove bending plate is used for component inspection and clamping in mechanical processing.The specific use of T-shaped groove bending plate:it is used to inspect the 90°angle of the workpiece,check the mutual perpendicularity of the relevant surfaces of the components during equipment maintenance,and is also commonly used for marking by fitters.It can also be commonly used for inspection,installation,and vertical plane inspection of machine tools,and can check the verticality of workpieces on cast iron flat plates.It is suitable for mechanical and instrument inspection and inspection of non verticality between machine tools.

What are the precautions for using T-shaped groove bending plates

1.Bending plates should not be used or stored in damp,corrosive,high or low temperature environments.

2.When using,it is necessary to install and debug the bending plate,then wipe the working surface of the bending plate clean,and use the bending plate only after confirming that there are no problems.

T-groove bending accuracy:can be divided into levels 000,00,0,1,2,and 3.The selection of accuracy standards is generally determined according to the usage situation.Bends with a precision of level 3 or above are used for inspection,marking,assembly,etc.,while bends with a precision of level 4 or below are generally used for riveting,welding,etc.

Introduction to technical parameters of T-shaped groove bending plate:The specifications of T-shaped groove bending plate mainly include 200mm x 300mm x 2000mm x 4000mm(larger specifications can be customized according to the drawings).We will customize different specifications of bending plates according to customer requirements to facilitate their bending needs.